KK V5.5 Multicopter Control Board +USB Fireware Loader USBasp Programmer
100% Brand new
Newest KKmulticopter V5.5 controller Board,Quadcopter V2.3 program
1. Simple structure, Easy to Maintain and Debug Control
2. with 3 pcs gyros, relying on potentiometer adjust gyro sensitivity.
3. Full servo signal output, support normal ESC / analog servo
4. Support for single-axis / UFO, Y3 3-axis, Y3-type 3-axis, 4 axis, 6 axis, V22 flight mode
5. Supports 4-axis "+" and "X" flight mode, support for six-axis "HEXA6" and "Y6" flight mode.
6. Don't need MK 4-axis PPM decoder board, the receiver can be connected directly to the Transmitter.
Special customized USBasp programmer for KK Flight control Circuit board, connect with the KK Flight control Circuit board directly, It's very convenient for DIY your aircraft.
Notic: that this is not used for parameter adjustment, it's only for flash different firmware of the KK Flight control Circuit board!
USB Firmware Loader USBasp Programmer for KK multicopter Board KK board AVR USBasp ISP + 6 pin adapter
The USB Firmware Loader / Programmer (USB ASPa) is the hardware utility.
You can use it to change the flying mode of a KKmulticopter board by re-programming the internal flash of the board.
1x KK Multicopter Flight Control Board V5.5
1x USB Loader USBasp Programmer for KK Multicopter Board
Online buy cheapest products direct from Chinese supply at rcmodelpart.com