KK V5.5 Multicopter Controller Board Set for XCopter
OFFER TRACKING NUMBER FOR FREE BIG DEAL 3 in 1
*KK V5.5 Multicopter Controller Board ( x mode ) for Xcopter x1
*USBasp Programmer w/cable x1
*Power/ESC Board ( with T connector and cable ) x1
100% Brand New!
The newset QuadCopter V2.3 Program Latest KKmulticopter controller V5.5 Board
1. Simple structure, Easy to Maintain and Debug Control
2. Relying on potentiometer adjust gyro sensitivity.
3. Full servo signal output, support normal ESC / analog servo
4. Support for single-axis / UFO, Y3 3-axis, Y4-type 3-axis, 4 axis, 6 axis, V22 flight mode
5. Supports 4-axis "+" and "X" flight mode, support for six-axis "HEXA6" and "Y6" flight mode.
6. Don't need MK 4-axis PPM decoder board, the receiver can be connected directly to the Transmitter.
Special customized USBasp programmer for KK Flight control Circuit board, connect with the KK Flight control Circuit board directly, It's very convenient for DIY your aircraft. Notic: that this is not used for parameter adjustment, it's only for flash different firmware of the KK Flight control Circuit board! USB Firmware Loader USBasp Programmer for KK multicopter Board KK board AVR USBasp ISP + 6 pin adapter The USB Firmware Loader / Programmer (USB ASPa) is the hardware utility. You can use it to change the flying mode of a KKmulticopter board by re-programming the internal flash of the board.
This is the Power Board V2 for dirtect compatibility with the KK MultiCopter Control Board V5.5 . . .for Tri-copters, Quad-copters and upto six/eight Motors This is new design,and it can support ESC & LEDS in same time.
Online buy cheapest products direct from Chinese supply at rcmodelpart.com